Best Guide For Concrete Polishing



One of the industries that have undergone great evolution is the polishing industry. Many grinding companies have been developed and other many created. Still other companies will start as most people are getting into this industry. These companies can apply the ideas in this article to ensure that quality concrete polishing is done. The tips for Dunellen commerical epoxy flooring are explained well below.

The first thing that should be done in determining the surface hardness. A concrete hardness tester is the tool that is used for testing concrete hardness. This is to help in deciding on the right abrasives. The tip number nine is the one used for scraping first. Then the scratching is done in a descending order. This continues to a level where the tip cannot do scratching anymore. This is the level where the hardness is ok.

Then the concrete surface is then prepared. Sometimes one can get the coated floors. Then the right equipment is used to remove the coating. This depend on the type of coating. Holes and cracks can be found in some floors that need to be polished. The repairing of this holes and cracks should be done first. The next thing that should be done is gritting with the metal bond tooling to the level and flatness that is desired.

The next thing is the removal of tool marks. This is done through the use of transitional tooling. The transitional tools have the ability to get all the metal tool marks effective. This is done to a level where there is no tool mark that remains.

Then the floor is densified and hardened by vacuuming it. The pore and crack filer is used to densify and solidify the surface of the floor. Also vacuuming helps in protecting the floor from allowing water penetration and stain creation. The pooling of the floor can result hence care should be taken to prevent it from happening. This is because pooling leads to permanent stains that can make polishing hard.

Then, Dunellen industrial coatings and  concrete polishing is done. One is advised to start with the resign band. Then all the dust is removed that is, the space is vacuumed in between the passes. Then the floor is burnished with a burnishing pad after the final grit level is achieved.

Then the last thing that should be done to the floor is protecting it. The floor get the protection by the sealing it. Grease, oils and other chemicals that make the floor hard to clean are the things that the floor is protected from. The sealer can be applied with the use of a pump and allowed to coat. To leave the floor shining, burnishing is essential. Successful concrete polishing can be done with the tips given.

Comments: Leave Comment

* The email will not be published on the website.
This site was built using